Table of Contents
Advertisement
Installing the ONS 15454 M6 Shelf
Prerequisite
Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
Use the deep-front panel when ONS-SC+-10G-C pluggables are installed on ONS 15454 M6 shelf.
Note
When the deep front-panel is installed, the total chassis depth is 12.9 inches. The deep front-panel extends
from the rack by 1.8 inches.
Caution
The deep-front panel does not have a hinge and cannot be rotated like a standard door. Rotating the deep-front
panel can damage the deep-front panel, shelf hinges, other devices and cables placed below the ONS 15454
M6 shelf.
Procedure
Step 1
Connect the ground strap cable to the shelf:
a) Loosen and remove the ground nut from the shelf.
b) Insert the lug of the ground strap cable and tighten the nut on the shelf to a torque value of 11.5 in-lb (1.3
N-m). See the following figure.
NTP-G327 Install the Deep-Front Panel of the ONS 15454 M6 Shelf
Remove the temporary door by removing the tape on top of the door.
•
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf
, on page 57
•
DLP-G576 Open the Standard Door of the ONS 15454 M6 Shelf , on page
58
• Connect the chassis to the office ground. For detailed instructions on how to
ground the chassis, see the
Cisco CPT and Cisco ONS
•
NTP-G253 Install the ECU or ECU-S Module, on page 79
•
NTP-G524 Install the Power Modules in the ONS 15454 M6 Shelf , on page
85
•
NTP-G255 Install the LCD Module in the ONS 15454 M6 Shelf, on page 96
•
NTP-G256 Install Power and Ground to the ONS 15454 M6 Shelf , on page
100
•
NTP-G257 Install the Fan-Tray Assembly in the ONS 15454 M6 Shelf, on
page 118
•
NTP-G290 Install the Cable and Fiber Modules, on page 121
•
NTP-G312 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections
in Cisco ONS 15454 M6, on page 127
As needed
Onsite
None
Electrostatic Discharge and Grounding Guide for
Platforms.
Installing the ONS 15454 M6 Shelf
63
Advertisement
Table of Contents
