Cisco ONS 15454 M6 Installation Manual page 104

DLP-G571 Connect Office Power (AC) to the ONS 15454 M6 Shelf
Warning
This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the
service equipment complying with NFPA 70, the National Electrical Code (NEC). Statement 7012
Caution
The ONS 15454 M6 relies on the protective devices in the building installation to protect against short circuit,
overcurrent and ground faults. Ensure that the protective devices are properly rated and comply with national
and local codes.
Note Not more than 7 feet (2 m) of the power supply cable should be exposed between the equipment and the fiber
storage tray.
Caution
When terminating the frame ground, do not use soldering lug connectors, screwless (push-in) connectors,
quick connect connectors, or other friction-fit connectors.
Note
If the system loses power or if both the TNC, TNCE, TSC, or TSCE cards are reset, you must reset the ONS
15454 M6 clock. After powering down, the date defaults to January 1, 1970, 00:04:15. To reset the clock, see
the "NTP-G24 Setting Up Node Identification Information" procedure in the Cisco ONS 15454 DWDM
Control Card and Node Configuration Guide.
Procedure
Step 1
Verify that the AC power module is installed in Slot A or Slot B (or both) of the ONS 15454 M6.
Step 2 Attach the AC power cable to the cable connector in the AC power module (see the following figure).
Installing the ONS 15454 M6 Shelf
104
Installing the ONS 15454 M6 Shelf