Cisco ONS 15454 M6 Installation Manual page 139

Installing the ONS 15454 M6 Shelf
NTP-G309 Connect the ONS 15454 M6 and the ONS 15454 in a
Mixed Multishelf Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The MSM (multishelf management) ports are present on the ECU module. The MSM ports located on the left
side of the ECU module corresponds to the TNC/TNCE/TSC/TSCE card in Slot 1, and the MSM ports located
on the right side corresponds to the TNC/TNCE/TSC/TSCE card in Slot 8. For more information about the
ECU module and MSM ports, see the
Procedure
Step 1 Complete the necessary task as applicable:
• To connect the ONS 15454 M6 as the node controller and ONS 15454 or ONS 15454 M6 as subtending
• To connect the ONS 15454 M6 as the node controller and ONS 15454 or ONS 15454 M6 as subtending
• To connect the ONS 15454 as the node controller and ONS 15454 or ONS 15454 M6 as subtending
Step 2
Complete the necessary task as applicable:
NTP-G309 Connect the ONS 15454 M6 and the ONS 15454 in a Mixed Multishelf Configuration
Use this procedure to connect the ONS 15454 M6 and the ONS 15454 with Cisco
Catalyst 3560 in a mixed multishelf configuration and configure the Catalyst 3560
using IOS commands.
• Two Cisco Catalyst 3560 switches must be installed in same rack as the node
controller shelf; see the Cisco Catalyst 3560 product documentation for
installation instructions.
• Cross-over (CAT-5) LAN cables (3, plus 2 for each subtending shelf)
NTP-G15 Install the Common Control
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card
As needed
Onsite
None
shelves with Catalyst 3560, complete the
in a Mixed Multishelf Configuration Using the Catalyst 3560, on page
shelves without a Catalyst switch, complete the
Controller in a Mixed Multishelf Configuration without a Catalyst Switch, on page
shelves with Catalyst 3560, complete the
a Mixed Multishelf Configuration, on page
External Connection Units, on page
DLP-G682 Connect the ONS 15454 M6 as the Node Controller
DLP-G729 Connect the ONS 15454 M6 as the Node
DLP-G683 Connect the ONS 15454 as the Node Controller in
145.
Installing the ONS 15454 M6 Shelf
Cards.
72.
140.
143.
139