Table of Contents
Advertisement
DLP-297 Install Timing Wires in ONS 15454 M6 - ETSI
Note
Figure 101: ECU module Wire-wrap Cabling ANSI
Step 3
Repeat for each cable. Refer to ITU-T G.813 for rules about provisioning timing references.
Step 4
Return to your originating procedure (NTP).
DLP-297 Install Timing Wires in ONS 15454 M6 - ETSI
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Connect the clock cable to the corresponding ECU module connector using a coaxial cable with DIN-1.0/2.3
miniature coaxial connectors.
Installing the ONS 15454 M6 Shelf
134
Route the wire-wrap connections as shown in the following figure to prevent interference with the
MSM ports.
This task installs the timing cables on the ONS 15454 M6 ECU module for ETSI.
75-ohm coaxial cable with a DIN-1.0/2.3 miniature coaxial connector. The PID
for the BITS IN/OUT cable is 15454-M-TMGCBL=
NTP-G253 Install the ECU or ECU-S Module, on page
As needed
Onsite
None
Figure 102: ECU module ETSI BITS connectors, on page 135
Installing the ONS 15454 M6 Shelf
79.
shows the ECU
Advertisement
Table of Contents
