Table of Contents
Advertisement
IGSMV / IGSMVCN Installation and Setup Guide
PROMPTS
Invert Zn7 Y/N
64
(N)_
Restore Zn7 Y/N
65
(Y)_
Delay Zn7 (secs)
66
(00)_
Rpt Zn7 ONLY if
67
Armed (N)_
Restore Zn8 Y/N
68
(Y)_
Delay Zn8 (secs)
69
(00)_
Use DHCP Y/N
70
(Y)_
NIC IP Address:
71
255.255.255.255_
Subnet Mask:
72
255.255.255.255_
Gateway IP Addr:
73
255.255.255.255_
DNS Serv IP
74
Addr:
255.255.255.255_
Enable Pwr Save
75
(Y)_
3-20
4204/
ZONE
ENTRY
TRIG.
2-4204
4204
only
2-
4204
only
2-
4204
only
OPTIONS
[Y], [N]
Inverts the alarm and normal states of the
zone 7 trigger; otherwise uses normal input
signal.
[Y], [N]
Enables restore reporting for zone 7.
Zone Trigger mode: This question will only
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL/ULC: Must be set to "Y."
[01-15]
Defines the reporting delay in seconds for
zone 7.
[00] = no delay
Zone Trigger mode: This question will only
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL/ULC: Must be set to "00."
[Y], [N]
Reports alarms on zone 7 ONLY if the
conditional zone (zone 4 in 4204 mode; zone 8
in 2-4204 mode) is triggered (armed).
If [N], always reports alarms on zone 7.
2-4204 mode: If any zone is programmed to
"Report Only if Armed," or if tamper is
enabled, skip to Prompt 70: "Use DHCP."
[Y], [N]
Enables restore reporting for zone 8.
UL/ULC: Must be set to "Y."
[01-15]
Defines the reporting delay in seconds for
zone 8.
[00] = no delay
UL/ULC: Must be set to "00."
[Y], [N]
Dynamically allocates the IP addresses
(recommended); then skip to Prompt 75:
"Enable Pwr Save". If [N], uses fixed IP
addresses.
12 digit:
Enter the 4-part address for this device. The
4 parts of the address must be separated by
xxx.xxx.xxx.xx
x
spaces (displayed as periods in Review mode).
12 digit:
Enter the 32-bit address mask used to
xxx.xxx.xxx.xx
indicate the portion (bits) of the IP address
x
that is being used for the subnet address.
The 4 parts of the address must be separated
by spaces (displayed as periods in Review
mode).
12 digit:
Enter the 4-part address assigned to the
xxx.xxx.xxx.xx
Gateway. The 4 parts of the address must be
x
separated by spaces (displayed as periods in
Review mode).
12 digit:
Enter the 4-part IP address assigned to the
xxx.xxx.xxx.xx
DNS (Domain Name System) server. The 4
x
parts of the address must be separated by
spaces (displayed as periods in Review mode).
[Y], [N]
To meet the 24 hour UL battery backup
requirement, choose "Y" to enable this
feature. If this causes connectivity problems
with certain routers or switches, then choose
"N" and wire the communications module so
it is powered from a UL listed UPS.
DESCRIPTION
Advertisement
Table of Contents
