NETGEAR ReadyDATA 5200 Software Manual page 55

Item
VLAN ID
Bandwidth Limit (Mbps) Enter the bandwidth limit in Mbps. Depending on the Ethernet interfaces that are
7. Click the TCP/IP tab.
The IP settings display. The IPv4 and IPv6 settings are mutually exclusive.
8. Select whether to use IPv4 or IPv6.
When you select a configuration method from the Configure IPv4 drop-down list, the IPv6
settings are dimmed; when you select a configuration method from the Configure IPv6
drop-down list, the IPv4 settings are dimmed.
The following figure shows the IPv4 settings; the next figure shows the IPv6 settings.
ReadyDATA OS 1.2
Description
Enter a VLAN ID. The default setting ID is 0.
Note: If you use VLAN IDs, the switch to which you connect the ReadyDATA
5200 needs to support VLAN tagging.
installed in the ReadyDATA 5200, the maximum limit is either 1,000 Mbps or
10,000 Mbps.
Configure the System Settings
55