NETGEAR ReadyDATA 5200 Software Manual page 43

3. From the Time Zone drop-down list, select the correct time zone for your location.
So that your files are correctly time-stamped, NETGEAR recommends that you select the
time zone in which the ReadyDATA 5200 is physically located.
4. Select the correct date and time by doing one of the following:
• Select the Synchronize clock with an Internet server check box. When you select
this check box, the calendar and time drop-down lists dim, and the system's date and
time are synchronized with a NETGEAR NTP server.
• Clear the Synchronize clock with an Internet server check box, and use the
calendar and time drop-down lists to set the date and time manually.
5. Click Apply.
If you change the time zone, you need to restart the ReadyDATA 5200, as follows:
a. Click the Power icon in the upper right corner of the navigation bar:
b. From the drop-down list, select Restart.
c. Confirm your selection.
The ReadyDATA 5200 shuts down gracefully and then restarts.
If you enabled email alerts, the ReadyDATA 5200 sends a message after it restarts.
ReadyDATA OS 1.2
Configure the System Settings
43