Ntp- D78 Create A Monitor Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 7 Manage Circuits
Complete the
Step 1
to delete the circuit. If you are already logged in, continue with Step 2.
As needed, complete the
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
As needed, complete the
Step 5
Stop. You have completed this procedure.
NTP-D78 Create a Monitor Circuit
Purpose
Tools/Equipment
Prerequisite Procedures Bidirectional (2-way) circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Monitor circuits cannot be used with EtherSwitch circuits.
Note
For unidirectional circuits, create a drop to the port where the test equipment is attached.
Note
Complete the
Step 1
create the monitor circuit. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Circuits tab.
Step 3
Choose the bidirectional (2-way) circuit that you want to monitor and double-click it (or click Edit).
Step 4
Verify that the circuit name is no longer than 44 characters. Monitor circuits append a "_MON" to the
Step 5
circuit name. If the name is longer than 44 characters, edit the name in the Name field, then click Apply.
In the Edit Circuit window, click the Monitors tab.
Step 6
The Monitors tab provides ports that you can use to monitor the circuit. The Monitor tab is only available
when the circuit has a DISCOVERED status.
In the Monitors tab, choose the monitor source port. The monitor circuit will show traffic coming into
Step 7
the node at the port you choose.
Click Create Monitor Circuit.
Step 8
In the Circuit Destination section of the Circuit Creation wizard, choose the destination node, slot, port,
Step 9
and if applicable, VC for the monitored circuit.
78-17194-01
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D29 Change Tunnel Type" task on page
"DLP-D30 Repair an IP Tunnel" task on page
"DLP-D31 Delete Overhead Circuits" task on page
"DLP-D207 Delete a Server Trail" task on page
This procedure creates a monitor circuit that monitors traffic on primary,
bidirectional circuits on E1 or STM-1 cards.
None
"Create Circuits and Low-Order Tunnels"
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49

NTP- D78 Create a Monitor Circuit

for a node on the network where you want
17-24.
17-25.
17-25.
19-5.
for circuit creation procedures.
at a node on the network where you will
Cisco ONS 15454 SDH Procedure Guide, R7.0
Chapter 6,
7-5