Table 20-11 Line Thresholds Options For E1-N-14 And E1-42 Cards - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-10
Parameter
Admin State
Service State (Display only) Identifies the
AINS Soak
Table 20-11
Table 20-11
Parameter
Port
CV
ES
78-17194-01
Line Options for E1-N-14 and E1-42 Cards (continued)
Description
Sets the port service state
unless network conditions
prevent the change. For more
information about
administrative states, refer to
the "Administrative and
Service States" appendix of
the Cisco ONS 15454 SDH
Reference Manual.
autonomously generated state
that gives the overall
condition of the port. Service
states appear in the format:
Primary State-Primary State
Qualifier, Secondary State.
For more information about
service states, refer to the
"Administrative and Service
States" appendix of the
Cisco ONS 15454 SDH
Reference Manual.
Sets the automatic in-service
soak period.
describes the values on the Provisioning > Line Thresholds tab for the E-1 cards.
Line Thresholds Options for E1-N-14 and E1-42 Cards
Description
(Display only) Port number
1 to 14 (E1-N-14 card)
•
1 to 42 (E1-42 card)
•
Coding violations
Errored seconds
DLP- D365 Change Line and Threshold Settings for E1-N-14 or E1-42 Cards
Options
Unlocked—Puts the port in service. The port
•
service state changes to Unlocked-enabled.
Unlocked,automaticInService—Puts the port in
•
automatic in-service. The port service state changes
to Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port from service
and disables it. The port service state changes to
Locked-enabled,disabled.
Locked,maintenance—Removes the port from
•
service for maintenance. The port service state
changes to Locked-enabled,maintenance.
Unlocked-enabled—The port is fully operational
•
and performing as provisioned.
Unlocked-disabled,automaticInService—The port
•
is out-of-service, but traffic is carried. Alarm
reporting is suppressed. The ONS node monitors
the ports for an error-free signal. After an error-free
signal is detected, the port stays in the
Unlocked-disabled,automaticInService state for the
duration of the soak period. After the soak period
ends, the port service state changes to
Unlocked-enabled.
• Locked-enabled,disabled—The port is
out-of-service and unable to carry traffic.
• Locked-enabled,maintenance—The port is
out-of-service for maintenance. Alarm reporting is
suppressed, but traffic is carried and loopbacks are
allowed.
Duration of valid input signal, in hh.mm format,
•
after which the card becomes Unlocked-enabled
automatically
0 to 48 hours, 15-minute increments
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-41