Table 20-27 Fc_Mr-4 Card General Port Settings - Cisco ONS 15454 SDH Procedure Manual

DLP- D354 Change General Port Settings for the FC_MR-4 Card
Table 20-27
Parameter
Port
Port Name
Admin State
Service State
Port Rate
Link Rate
Max GBIC
Rate
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-60
FC_MR-4 Card General Port Settings
Description
(Display only) Displays the port number.
Provides the ability to assign the specified
port a name.
Changes the port service state unless
network conditions prevent the change.
Identifies the autonomously generated state
that gives the overall condition of the port.
Service states appear in the format: Primary
State-Primary State Qualifier, Secondary
State.
Selects the Fibre Channel interface.
Displays the actual rate of the port.
Displays the maximum GBIC rate. Cisco
supports two GBICs for the FC_MR-4 card
(ONS-GX-2FC-SML and
ONS-GX-2FC-MMI). If used with another
GBIC, the field shows "Contact GBIC
vendor."
Chapter 20 DLPs D300 to D399
Options
1 through 4
User-defined. Name can be up to
32 alphanumeric/special characters.
Blank by default.
See the "DLP-D314 Assign a Name to a
Port" task on page 20-7.
• Unlocked—Puts the port in service.
The port service state changes to
Unlocked-enabled.
Locked,disabled—Removes the port
•
from service and disables it. The
port service state changes to
Locked-enabled,disabled.
Locked,maintenance—Removes the
•
port from service for maintenance.
The port service state changes to
Locked-enabled,maintenance.
Unlocked-enabled—The port is
•
fully operational and performing as
provisioned.
Locked-enabled,disabled—The port
•
is out-of-service and unable to carry
traffic.
Locked-enabled,maintenance—The
•
port is out-of-service for
maintenance. Alarm reporting is
suppressed, but traffic is carried and
loopbacks are allowed.
1 Gbps
•
2 Gbps
•
—
—
78-17194-01