Before You Begin - Cisco ONS 15454 SDH Procedure Manual

Turn Up a Node
This chapter explains how to provision a single Cisco ONS 15454 SDH node and turn it up for service,
including node name, date and time, timing references, network attributes such as IP address and default
router, users and user security, and card protection groups.

Before You Begin

Complete the procedures applicable to your site plan from the following chapters:
•
•
•
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
78-17194-01
Chapter 1, "Install the Shelf and FMECs"
Chapter 2, "Install Cards and Fiber-Optic Cable"
Chapter 3, "Connect the PC and Log into the GUI"
NTP-D24 Verify Card Installation, page
NTP-D30 Create Users and Assign Security, page
Cisco Transport Controller (CTC) users and assign their security levels.
NTP-D316 Set Up Name, Date, Time, and Contact Information, page
procedure to set the node name, date, time, location, and contact information.
NTP-D279 Set Power Monitor Thresholds, page
battery power thresholds.
NTP-D169 Set Up CTC Network Access, page
IP address, default router, subnet mask, and network configuration settings.
NTP-A360 Enable EMS Secure Access, page
secure access and provide enhanced SFTP and SSH security.
NTP-D27 Set Up the ONS 15454 SDH for Firewall Access, page
if the ONS 15454 SDH will be accessed behind firewalls.
NTP-D28 Set Up Timing, page
references.
NTP-D170 Create Protection Groups, page
1:N, or 1+1 protection groups for ONS 15454 SDH electrical and optical cards.
NTP-D34 Set Up SNMP, page
Protocol (SNMP) will be used for network monitoring.
C H A P T E R
4-2—Complete this procedure first.
4-4—Continue with this procedure to create
4-6—Continue with this procedure to set the node
4-7—Continue with this procedure to provision the
4-8—Continue with this procedure to enable EMS
4-9—Continue with this procedure to set up the node's SDH timing
4-10—Complete this procedure, as needed, to set up 1:1,
4-12—Complete this procedure if Simple Network Management
Cisco ONS 15454 SDH Procedure Guide, R7.0
4
4-4—Continue with this
4-8—Continue with this procedure
4-1