Table of Contents
Advertisement
Setting error information (addresses 60–63)
1.
If a parameter value outside the default range is set (in the PLC program), the
respective bit will be set to 1 for the specified channel.
2.
Memory addresses 60 to 63 are used to indicate the error information for channel 0
to 3, respectively.
3.
Setting error can be reset if the input value is in normal range.
4.
There will be no change in the module LED when setting error occurs. If more than
1 bit of UXY.01.08–UXY.01.0B is turned ON, check the area and its settings.
5.
Error details and setting address of applicable bits are shown in the Table 10.
Bit
Bit 0:
Setting error of CH sensor type (addresses 1–4)
Bit 1:
Setting error of CH filter value (addresses 6–9)
Bit 2:
Setting error of CH averaging type (addresses 10–13)
Bit 3:
Setting error of CH averaging value (addresses 14–17)
Bit 4:
Setting error of CH scale min. range (addresses 19, 21, 23, 25)
Bit 5:
Setting error of CH scale max. range (addresses 20, 22, 24, 26)
Bit 6:
Setting error of CH process alarm HH value (addresses 27,31,35,39)
Bit 7:
Setting error of CH process alarm H value (addresses 28, 32, 36, 40)
Bit 8:
Setting error of CH process alarm L value (addresses 29, 33, 37, 41)
Bit 9:
Setting error of CH process alarm LL. value (addresses 30, 34, 38, 42)
Bit A:
Setting error of CH process alarm hysteresis (addresses 39–46)
Bit B:
Setting error of CH input variation alarm max. value (addresses 48, 50, 52,
54)
Bit C:
Setting error of CH input variation alarm min. value (addresses 49, 51, 53,
55)
Bit D:
Setting error of CH input variation alarm detection cycle (addresses 56–59)
R200
Resistance Temperature Detector 2MLF-RD4A User's Guide
September 2010
5. Internal Memory Configuration and Functions
Table 10 – Error information address
Description
Honeywell
5.3. Operation parameters setting area
107
Advertisement
Table of Contents
Troubleshooting
