Remote Reprogramming - GE MDS SD Series Technical Manual

Remote
Reprogramming
64
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
The transceiver has facilities for reprogramming key settings of other
radios in the network. These functions are contained on the Remote
Reprogramming screen shown below. Additional information on remote
reprogramming is given in "Over-the-Air Firmware Upgrades" on
Page 76.
• —Set to either intrusive or passive as desired.
Channel Usage
• —Used to specify the size of the reprogramming
Packet Data Size
data packets. Default size is
• —Used to specify the number of times a transmission
Retry Count
is repeated when a packet is not received correctly. Default set-
ting is .
3
•
Reprogram Block Size
each data packet. Default setting is
• —When enabled, causes the transceiver to automati-
Auto-Reboot
cally reboot after a firmware image upgrade. If disabled, the
newly loaded image will not become valid until the transceiver is
rebooted.
• —This field can be used to introduce a time delay
Download Delay
as to when reprogramming begins. Typically, it is set to
may be increased incrementally by selecting one of the extended
delay times from the drop-down box (
SD Series Technical Manual
.
40
—Sets the overall block size (in bytes) of
.
512
Extended Delay-1, 2, 3
MDS 05-4846A01, Rev. D
, but
None
)