Accessories And Spares - GE MDS SD Series Technical Manual

6
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
Figure 3. SD Transceivers offer compatibility with older MDS x710
Transceivers (right), and may be used for replacement and/or
interoperability in these networks. A retrofit kit is available for
connector conversion (see Table 1).

2.5 Accessories and Spares

Table 1 lists common accessories and spare items for the transceiver.
GE MDS also offers an Accessories Selection Guide listing additional
items that may be used with the product. Visit
your factory representative to obtain a copy of the guide.
Table 1. Accessories & Spare Items
Accessory Description
DC Power Plug, Mates with power connector on radio
2-pin, polarized case. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect.
Retrofit Kit, Digital Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
digital transceiver.
Retrofit Kit, Analog Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
analog transceiver.
Setup Guide Describes the installation and setup
(for Packet and of the transceiver. A companion to
Transparent Modes) this Technical Manual.
Flat Mounting Brackets that attach to the bottom of
the unit. Used for mounting to a flat
Brackets
(Standard) mounting surface.
Flat Mounting Brackets that attach to the bottom of
Brackets the unit. Used for mounting to a flat
(x710-compatible) mounting surface. Bracket matches
MDS x710 Transceiver mounting
holes.
SD Series Technical Manual
Invisible place holder
or contact
www.gemds.com
Part Number
73-1194A53
03-4696A01
03-4697A01
05-4847A01
03-4123A14
Consult
Factory
MDS 05-4846A01, Rev. D