Packet Settings - GE MDS SD Series Technical Manual

Packet Settings

42
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
• —The radio can operate in one of several modes. The
Radio Mode
available selections are: Packet, Packet with MAC, x710, and
Transparent.
• —This parameter selects the method of radio man-
User Interface
agement. The default selection is
screens shown in this manual. Alternatively, you may select
which switches the radio to a Command Line Interface. With a
CLI interface, commands are entered in text-based fashion, as
described in the SD Serial/Telnet Management Supplement, Part
No. 05-6193A01 more information.
•
COM1/COM2 Port Inter-Packet Gap
packet on the serial interface for radios operating in Packet Mode.
Too short of a time can cause serial streams to be combined into
one large packet instead of two smaller ones. Too long of a time
can effectively slow down the communications channel. The
Inter-Packet Gap is specified by the number of character times
(the time it takes to send an individual character).
•
Transparent RX Timeout (ms)
parameters for
COM1/COM2 Inter-Packet Gap
received over-the-air. It tells the radio how to build an Ethernet
packet based on a transparent data stream received over the radio
channel.
SD Series Technical Manual
, which presents the type of
Menu
—Timing setting used to delimit a
—This setting is similar to the timing
, but it applies to data
MDS 05-4846A01, Rev. D
,
CLI