Reference Mode - ABB ACS310 User Manual



Reference mode

In the Reference mode, you can:
• set the frequency reference
• start, stop, change the direction and switch between local and remote control.
How to set the frequency reference
Step Action
1. Go to the Main menu by pressing
the Output mode, otherwise by pressing
repeatedly until you see MENU at the bottom.
2. If the drive is in remote control (REM shown on the
left), switch to local control by pressing
display briefly shows "LoC" before switching to local
control.
Note: With group
can allow the reference modification in remote
control (REM).
3. If the panel is not in the Reference mode ("rEF" not
visible), press key
and then press
current reference value with
4. • To increase the reference value, press
• To decrease the reference value, press
The value changes immediately when you press the
key. It is stored in the drive permanent memory and
restored automatically after power switch-off.
www.aotewell.com
11 REFERENCE SELECT, you
or until you see "rEF"
. Now the display shows the
under the value.
SET
sales@aotewell.com
if you are in
REM
LOC
. The
LOC
REM
LOC
LOC
.
LOC
.
Industry Automation
Control panels 75
Display
PAr
MENU FWD
PAr
MENU FWD
rEF
MENU FWD
491
.
Hz
SET FWD
500
.
Hz
SET FWD
+86-755-8660-6182