Accel/Decel - ABB ACS310 User Manual

204 Actual signals and parameters
All parameters
No. Name/Value
DI1
DI2
DI3
DI4
DI5
COMM
ON
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)

22 ACCEL/DECEL

2201 ACC/DEC 1/2
SEL
NOT SEL
DI1
DI2
DI3
DI4
DI5
COMM
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
www.aotewell.com
Description
Digital input DI1.
1 = Motor heating is On.
0 = Motor heating is Off.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Serial communication as the control for motor heating.
Motor heating active (during stop)
Inverted digital input DI. 0 = Motor heating On 1 = Motor
heating Off.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Acceleration and deceleration times
Defines the source from which the drive reads the signal
that selects between the two ramp pairs,
acceleration/deceleration pair 1 and 2.
Ramp pair 1 is defined by parameters 2202...2204.
Ramp pair 2 is defined by parameters 2205...2207.
Ramp pair 1 is used.
Digital input DI1. 1 = ramp pair 2, 0 = ramp pair 1.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Fieldbus interface as the source for ramp pair 1/2 selection,
ie Control word 0301 FB CMD WORD 1
word is sent by the fieldbus controller through the
embedded fieldbus (Modbus) to the drive. For the Control
word bits, see section
307.
Note: This setting applies only for the DCU profile.
Inverted digital input DI1. 0 = ramp pair 2, 1 = ramp pair 1.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
sales@aotewell.com
bit 10. The Control
DCU communication profile
Industry Automation
Def/FbEq
1
2
3
4
5
7
8
-1
-2
-3
-4
-5
DI5
0
1
2
3
4
5
7
on page
-1
-2
-3
-4
-5
+86-755-8660-6182