Relay Outputs - ABB ACS310 User Manual

188 Actual signals and parameters
All parameters
No. Name/Value
-100.0...100.0% See parameter
1306 FILTER AI2
0.0...10.0 s
14 RELAY OUTPUTS Status information indicated through relay output, and relay
1401 RELAY
OUTPUT 1
NOT SEL
READY
RUN
FAULT(-1)
FAULT
ALARM
REVERSED
STARTED
SUPRV1
OVER
SUPRV1
UNDER
SUPRV2
OVER
SUPRV2
UNDER
SUPRV3
OVER
SUPRV3
UNDER
AT SET POINT Output frequency is equal to the reference frequency.
FAULT(RST)
FLT/ALARM
EXT CTRL
REF 2 SEL
www.aotewell.com
Description
1302 MAXIMUM
Defines the filter time constant for analog input AI2. See
parameter 1303 FILTER
Filter time constant
operating delays.
Note: Relay outputs 2...4 are available only if the MREL
relay output extension module is connected to the drive.
See MREL-01 relay output extension module user's manual
(3AUA0000035974 [English]).
Selects a drive status indicated through relay output RO 1.
The relay energizes when the status meets the setting.
Not used
Ready to function: Run enable signal on, no fault, supply
voltage within acceptable range and emergency stop signal
off.
Running: Start signal on, Run enable signal on, no active
fault.
Inverted fault. Relay is de-energized on a fault trip.
If fault is handled by autoreset, then the relay does not de-
energize.
Fault. Relay is energized on a fault trip.
If fault is handled by autoreset, then the relay does not
energize.
Alarm
Motor rotates in reverse direction.
The drive has received start command. Relay is energized
even if Run enable signal is off. Relay is de-energized when
drive receives a stop command or a fault occurs.
Status according to supervision parameters 3201...3203.
See parameter group
See selection SUPRV1
Status according to supervision parameters 3204...3206.
See parameter group
See selection SUPRV2
Status according to supervision parameters 3207...3209.
See parameter group
See selection SUPRV3
Fault. Automatic reset after the autoreset delay. See
parameter group 31 AUTOMATIC
Fault or alarm
Drive is under external control.
External reference REF 2 is in use.
sales@aotewell.com
AI1.
AI1.
32 SUPERVISION.
OVER.
32 SUPERVISION.
OVER.
32 SUPERVISION.
OVER.
RESET.
Industry Automation
Def/FbEq
1 = 0.1%
0.1 s
1 = 0.1 s
FAULT(-1)
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
+86-755-8660-6182