Time 2 - ABB ACS310 User Manual

180 Actual signals and parameters
All parameters
No. Name/Value
1103 REF1 SELECT Selects the signal source for external reference REF1. See
KEYPAD
AI1
AI2
AI1/JOYST
AI2/JOYST
DI3U,4D(R)
DI3U,4D
COMM
COMM+AI1
COMM*AI1
www.aotewell.com
Description
section Block diagram: Reference source for EXT1
121.
Control panel
Analog input AI1
Analog input AI2
Analog input AI1 as joystick. The minimum input signal runs
the motor at the maximum reference in the reverse
direction, the maximum input at the maximum reference in
the forward direction. Minimum and maximum references
are defined by parameters
MAX.
Note: Parameter 1003 DIRECTION
REQUEST.
par. 1301
Speed ref
(REF1)
1105
1104
0
-1104
-1105
2 V / 4 mA
WARNING! If parameter
0 V and analog input signal is lost (ie 0 V), the rotation
of the motor is reversed to the maximum reference. Set the
following parameters to activate a fault when analog input
signal is lost:
Set parameter 1301 MINIMUM AI1
Set parameter 3021 AI1 FAULT LIMIT
Set parameter 3001 AI<MIN FUNCTION
See selection AI1/JOYST.
Digital input DI3: Reference increase. Digital input DI4:
Reference decrease. Stop command resets the reference to
zero. Parameter 2205 ACCELER TIME 2
the reference change.
Digital input DI3: Reference increase. Digital input DI4:
Reference decrease. The program stores the active speed
reference (not reset by a stop command). When the drive is
restarted, the motor ramps up at the selected acceleration
rate to the stored reference. Parameter

TIME 2

defines the rate of the reference change.
Fieldbus reference REF1
Summation of fieldbus reference REF1 and analog input AI.
See section Reference selection and correction
294.
Multiplication of fieldbus reference REF1 and analog input
AI1. See section Reference selection and correction
page 294.
sales@aotewell.com
1104 REF1 MIN
must be set to
= 20%, par 1302 = 100%
AI1
-1104
6 10 V / 20 mA
1301 MINIMUM AI1
to 20% (2 V or 4 mA).
to 5% or higher.
to FAULT.
defines the rate of
2205 ACCELER
Industry Automation
Def/FbEq
AI1
on page
0
1
2
3
and 1105 REF1
1104
- 2% +2 %
Hysteresis 4%
of full scale
is set to
4
5
6
8
9
on page
10
on
+86-755-8660-6182