Flow Configuration - Honeywell SMV800 User Manual

2.3.5. Flow Configuration

This tab provides the detail information about the Flow parameters.
Refer the below table for Flow Configuration:
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
Flow Config
Flow
Flow LRV
Flow URV
Flow Damping
Flow URL
Flow LRL
Revision 1.0
Flow Configuration parameters
The current value of the calculated Flow
The Lower Range Value for the Flow input
(which represents 0% output) in user selected
engineering units. This value may be
configured to any value within the range Flow
LTL to Flow UTL.
The Upper Range Value for the Flow input
(which represents 100% output) in user
selected engineering units. This value may be
configured to any value within the range Flow
LTL to Flow UTL.
Damping value for the Flow output. Entries
may be any value from 0.00 to 32.00 seconds.
The upper limit for Flow damping is 100.
The Upper Range Limit for the Flow input
(editable)
The Lower Range Limit for the Flow input
SMV800 Modbus User's Guide Page 23