Honeywell SMV800 User Manual page 24

Refer to the below table for Device Information:
Key: Plain = Read only Bold = Configurable
Manufacturer
Device Model
Device Revision
Software Rev
Pressure FW Rev
Temperature FW Rev
Display FW Rev
Communication FW Rev
Model Number
Long Tag
Date
Tag
Write Protect
Transmitter Install Date
Temp Module Install Date
Final Assembly Number
Serial Number
Message
Clear Message
Page 12
Bold underline = Method Bold italic = Table or
graph
Honeywell
Displays Model or Device Type of SMV800
Transmitter
Displays Field Device Revision of the SMV800
Transmitter
Software revision
Pressure Sensor Board Firmware Version
Temperature Sensor Board Firmware Version
Display Board Firmware Version
Communication board Firmware Version
Displays the model number of the device
Enter Tag ID name up to 32 characters
Gregorian calendar date that is stored in the Field
Device. This date can be used by the user in any
way.
Enter Tag ID name up to 8 characters
Indicates the current state of the device write protect
option as enabled (yes) or disabled (no)
(One time editable) Transmitter installation date in
MM/DD/YYYY format.
Note : If install date is not present then it will show
default install date as 01/01/1978
(One time editable) Temperature Module installation
date in MM/DD/YYYY format.
Note: If install date is not present then it will show
default install date as 01/01/1978
Used for identifying electronic components. This
number can be used by the user in any way.
Shows serial number of the device.
Enter a message up to 32 alphanumeric
characters) that will be sent to the Display. The
message will be shown on the Display
interspersed with the configured screens.
Select to clear message from transmitter's local
display.
SMV800 Modbus User's Guide Revision 1.0