GE C70 Instruction Manual page 658

G.1 CHANGE NOTES
Table G–3: MAJOR UPDATES FOR C70 MANUAL REVISION Z1 (Sheet 2 of 2)
PAGE PAGE CHANGE
(Y3) (Z1)
2-10 2-10 Update
5-24 5-24 Add
5-87 5-87 Update
5-91 5-91 Update
5-228 5-228 Add
Table G–4: MAJOR UPDATES FOR C70 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
Table G–5: MAJOR UPDATES FOR C70 MANUAL REVISION Y2
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
All All Delete
1-1 1-1 Update
3-8 3-8 Update
Table G–6: MAJOR UPDATES FOR C70 MANUAL REVISION Y1 (Sheet 1 of 2)
PAGE PAGE CHANGE
(X2) (Y1)
G
All All Delete
Title Title Update
1-1 1-1 Update
2-4 2-4 Update
2-8 2-8 Delete
2-18 2-18 Update
3-8 3-8 Update
3-9 3-9 Update
3-22 3-22 Update
5-1 5-1 Update
5-15 5-15 Update
5-15 5-15 Delete
5-16 5-16 Add
5-16 5-16 Update
5-16 5-16 Update
5-39 5- Delete
5- 5-39 Add
5- 5-40 Add
G-2
DESCRIPTION
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-24 and 5-25 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-26 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
DESCRIPTION
Minor changes throughout document
Deleted CPU options U and V
Updated Figure 1-1 Rear Nameplate
Updated Figure 3-10 Rear Terminal View
DESCRIPTION
Deleted content pertaining to Ethernet switch
Changed part numbers. Updated address and contact information.
Updated address and contact information
Updated order code Tables 2-3 to 2-6
Deleted 9S, 2S, 2T from replacement module order codes Tables 2-7 and 2-8
Updated Ethernet fiber table in section 2.2.8 Communications
Updated Figure 3-10 Rear Terminal View
Updated Figure 3-12 Typical Wiring Diagram
Deleted references to COM 1 RS485 port in section 3.2.9 CPU Communication Ports. Revised
text and Figure 3-24 CPU Module Communications Wiring to include only modules T, U, V in
section 3.2.9a.
Updated the front panel main menu to include the CyberSentry security menu
Updated Communications main menu to remove the SNTP Protocol submenu
Deleted references to COM 1 RS485 port in section 5.2.4b Serial Ports
Added section 5.2.4c Ethernet Network Topology
Updated Networks section 5.2.4d to include all three Ethernet ports
Added 0 as valid number to section 5.2.4e Modbus Protocol section
Deleted Local Time Offset, Daylight Savings Time, DST (start/stop for month/day/hour) from Real
Time Clock menu
Added submenus Precision Time Protocol, SNTP Protocol, and Local Time and Synchronizing
Source settings to Real Time Clock menu
Added new Precision Time Protocol (1588) menu and setting descriptions
C70 Capacitor Bank Protection and Control System
APPENDIX G
GE Multilin