GE C70 Instruction Manual page 112

4.3 FACEPLATE INTERFACE
3. Enter the text to appear next to each LED and above each user-programmable pushbuttons in the fields provided.
4. Feed the C70 front panel label cutout sheet into a printer and press the Print button in the front panel report window.
5. When printing is complete, fold the sheet along the perforated lines and punch out the labels.
6. Remove the C70 label insert tool from the package and bend the tabs as described in the following procedures. These
tabs are used for removal of the default and custom LED labels.
It is important that the tool be used EXACTLY as shown below, with the printed side containing the GE part number
facing the user.
NOTE
The label package shipped with every C70 contains the three default labels shown below, the custom label template sheet,
and the label removal tool.
If the default labels are suitable for your application, insert them in the appropriate slots and program the LEDs to match
them. If you require custom labels, follow the procedures below to remove the original labels and insert the new ones.
The following procedure describes how to setup and use the label removal tool.
1. Bend the tabs at the left end of the tool upwards as shown below.
4
2. Bend the tab at the center of the tool tail as shown below.
The following procedure describes how to remove the LED labels from the C70 enhanced front panel and insert the custom
labels.
4-18 C70 Capacitor Bank Protection and Control System
4 HUMAN INTERFACES
GE Multilin