Cisco ONS 15454 Troubleshooting Manual page 65

Chapter 1 General Troubleshooting
To find the recovery tool file, go to the CISCO15454 directory on the CD (usually
Step 2
/cdrom/cdrom0/CISCO15454).
Step 3 If you are using a file explorer, double-click the RE-INIT.jar file to open the reinit tool
If you are working with a command line interface, run java -jar RE-INIT.jar.
Figure 1-29 Reinitialization Tool in UNIX
Step 4 If the node you are reinitializing is an ENE in a proxy server network, enter the IP address of the GNE
in the GNE IP field. If not, leave it blank.
Step 5 Enter the node name or IP address of the node you are reinitializing in the Node IP field
Step 6 If the User ID field does not contain your user ID, enter the ID. Enter your password in the Password
field.
Step 7 Verify that the Re-Init Database, Upload Package, and Confirm check boxes are checked. If one is not
checked, check the check box.
If you are uploading the same version of software that is already active (for example, you are trying to
Step 8
upload version 4.6 when version 4.6 is already active), check the Force Upload checkbox. This option
forces the NE to have the same software version on the working and protect flash memory.
In the Search Path field, verify that the path to the CISCO15454 folder on the CD-ROM drive is listed.
Step 9
Caution Before you perform the next step, be sure you are uploading the correct database. You cannot reverse the
upload process after you click Yes.
Step 10 Click Go. A confirmation dialog box appears.
Step 11 Click Yes.
Step 12 The status bar at the bottom of the screen displays Complete when the node has activated the software
and uploaded the database.
Note
Step 13 If you are logged into CTC, close the browser window and disconnect the straight-through LAN cable
from the RJ-45 (LAN) port on the TCC2 card or on the hub or switch where the ONS 15454 is physically
connected. Reconnect your straight-through LAN cable to the LAN port and log back into CTC.
November 2004
The Complete message only indicates that the TCC2 successfully uploaded the database; not that
the database restore was successful. The TCC2 then tries to restore the database after it reboots.
1.6.2 Restore the Node to Factory Configuration
Cisco ONS 15454 Troubleshooting Guide, R4.6
(Figure 1-29).
(Figure 1-29).
1-65