Cisco ONS 15454 Troubleshooting Manual page 86

1.8.17 Cross-Connect Card Oscillator Fails
Figure 1-33 Configuring VLAN Membership for Individual Ethernet Ports
If the port is set to Tagged, continue to look at other cards and their ports in the VLAN until you find the
Step 3
port that is set to Untag.
At the VLAN port set to Untag, click the port and choose Tagged.
Step 4
Note
After each port is in the appropriate VLAN, click Apply.
Step 5
1.8.17 Cross-Connect Card Oscillator Fails
Symptom: The XC or XCVT card can be affected by this problem. (In R4.6, the XC10G card
automatically detects it.) It is indicated by a CTNEQPT-PBPROT or CTNEQPT-PBWORK condition
raised against all I/O cards in the node. The following conditions might also be raised on the node:
•
•
•
•
Table 1-26
Cisco ONS 15454 Troubleshooting Guide, R4.6
1-86
The attached external devices must recognize IEEE 802.1Q VLANs.
SWMTXMOD against one or both cross-connect cards
SD-L against near-end or far-end line cards
AIS-L against far-end line cards
RFI-L against near-end line cards
describes the potential cause(s) of the symptom and the solution(s).
Chapter 1 General Troubleshooting
November 2004