Cisco D9800 Reference Manual page 210

Output Configuration Command
Command Detail
POST Syntax
Setting Parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
Note
Table 166: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
URI Argument
ipoid
iporate
encaps
dest_ip
dest_port
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
198
Description
Singlestream unit:
POST "https://192.168.0.1/ws/v2/service_cfg/output/moip/ipo?
ipoid=[Stream#]&iporate=<ipo rate>... "
Multistream unit:
POST "https://192.168.0.1/ws/v2/service_cfg/output/moip1/ipo?
ipoid=[Stream#]&iporate=<ipo rate>... "
POST "https://192.168.0.1/ws/v2/service_cfg/output/moip2/ipo?
ipoid=[Stream#]&iporate=<ipo rate>... "
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not
need any values, except the peid argument which must be supplied with a program entry ID value.
For POST, any of the below URI arguments can be supplied with their associated value the user
would like to set.
Description
Program Entry Identifier
Type: Integer
Values: 1...40 for D9800-MS with 8 Transcoders, 1...48 for MS with 16
Transcoders, 1..16 for D9800-SS
Bitrate (in Mbps) of Transport output stream
Type: Float
Values: 0.0...800.0
Encapsulation of Transport output stream
Type: String
Values: "RTP", "UDP"
Destination IP Address
Type: String
Values: IP address in the dot format, for example, 192.168.0.1
Destination IP Port
Type: Integer
Values: 1..65534
API Definitions