Cisco D9800 Reference Manual page 248

CA (Conditonal Access) Configuration Commands
Command Detail
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
Note
Table 200: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
URI Argument
port (Key)
Applies to multi-stream units only.
stream (Key)
(optional)
Applies to multi-stream units only.
bissmode
mod1seswrd
(Write Only)
modeseswrd
(Write Only)
modeinjid
(Write Only)
POST Examples:
Example 1: Set various BISS Setting Arguments
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
236
Description
POST "https://192.168.0.1/ws/v2/service_cfg/ca/biss?
bissmode=Mode%201"
For POST, the value for the argument seen below must be specified, but for GET there are no values
for arguments. Also, the write only commands that can be used for POST are noted below.
Description
Input port to be configured.
Type: Integer
Values: 1 .. 16 (NFE), 1 .. 2 (ASI), 2 (MOIP)
Multi Input Stream ID. If not specified, default value of 1 is used.
Type: Integer
Values: 1..6 (RF), 2 (ASI), 1..32 (MOIP)
BISS Mode of operation
Type: String
Value: "Mode 1", "Mode E"
Mode-1 Session Word
Type: String
Value: String with 12 characters
Mode-E Encrypted Session Word
Type: String
Value: String with 16 characters
Mode-e Injected ID
Type: String
Value: String with 14 characters
API Definitions