Cisco D9800 Reference Manual page 151

API Definitions
Setting Parameters using command line arguments are limited to maximum of 26 arguments after the ?.
Note
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not need
Note
any values, except the port which must be specified. For POST the port must be specified followed by
any of the below URI arguments and the associated value the user would like to set. In-depth CURL
examples can be seen below following the table.
Table 135: URI Query/Set Arguments
URI Argument
port (Key)
stream (Key)
(optional)
This is not applicable to
Version 1.x
act
dnlkfreq
symrate
Description
Input Port to be configured
Type: Integer
Values: 1 .. 16, range as shown below:
NFE1 : 1..4
NFE2: 5..8
NFE3: 9..12 8
NFE4: 12..16 8
This does not refer to the NTC Ethernet ports, it refers specifically
Note
to the RF ports.
Multi Input Stream ID. If not specified, default value of 1 is used
Type: Integer
Values: 1..6 (RF)
Activate Input
Type: String
Values: "Yes" or "No"
Downlink Frequency
Type: Float
Values: 0.0 .. 15.0
Symbol Rate
Type: Float
Values: 1.0 .. 45.0
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
Input Configuration Command
139