Configuring Auto Policy-Based Routing
Example:
The following example shows how to associate three IP addresses and ports to the group being configured.
> bind serviceGroup svc_grp_1 192.168.14.12 80
> bind serviceGroup svc_grp_1 192.168.14.13 80
> bind serviceGroup svc_grp_1 192.168.14.14 80
Step 3
> set serviceGroup service_name [-usip [yes]
Sets the specified service and enables the USIP option.
The -usip keyword is not required on each service if you use the add serviceGroup command with the -usip
Note
keyword.
Example:
> set serviceGroup svc_grp_1
The following example shows how to disable the USIP option on all members of a service group and delete the
corresponding APBR rules on the Cisco Nexus device:
unset serviceGroup svc_grp_1
Enabling the USIP Option Globally
To globally enable Use Source IP (USIP) on the Citrix Netscaler Application Delivery Controller (ADC)
appliance and set the USIP option on all services and service groups, enter the following command at the
command prompt
SUMMARY STEPS
1. > enable ns mode usip
DETAILED STEPS
> enable ns mode usip
Enables USIP on the Netscaler Application Delivery Controller (ADC) appliance. All subsequent added services are
APBR services.
Example:
The following example shows how to enable USIP on the Citrix Netscaler Application Delivery Controller (ADC)
appliance and then create a service for which the USIP option is set because the setting is inherited from the global
configuration:
> enable ns mode USIP
Done
> add service svc_gl 192.168.12.72 http 80
Done
Configuring APBR on the Citrix NetScaler Application Delivery Controller (ADC) Appliance
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
59