Configuring Rise In An Indirect Mode Deployment - Cisco Nexus 7000 Series Configuration Manual

Configuring RISE in an Indirect Mode Deployment

Command or Action
Step 12 switch(config-rise)# show rise
What to Do Next
After configuring RISE on the Cisco Nexus Series switch, the Citrix Netscaler Application Delivery
Note
Controller (ADC) appliance that is directly connected to the switch is automatically configured for RISE
mode and all of its ports are in operation mode. No further configuration is required to deploy RISE on
the Citrix Netscaler Application Delivery Controller (ADC) appliance.
Configuring RISE in an Indirect Mode Deployment
In an indirect mode deployment, a virtual service appliance, such as Citrix NetScaler Application Delivery
Controller (ADC) appliance, is connected to a Cisco Nexus Series switch through a switched Layer 2 network.
The topology in the following figure is for an indirect mode deployment.
Figure 7: Indirect Connect Mode Through a Layer 2 Network
This section includes the following topics:
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
24
Purpose
• After you enter the password, you can access the Citrix Netscaler Application
Delivery Controller (ADC) appliance to configure it.
Displays the RISE configuration status on the Cisco Nexus Series switch. If RISE is
configured on the switch, the state that is displayed is "active."
Configuring RISE