Enabling Apbr On The Cisco Nexus Switch; Configuring Apbr On The Citrix Netscaler Application Delivery Controller (Adc); Appliance; Configuring Nsip On The Appliance - Cisco Nexus 7000 Series Configuration Manual

Enabling APBR on the Cisco Nexus Switch

Enabling APBR on the Cisco Nexus Switch
You must enable the policy-based routing feature on the Cisco Nexus Series switch to support auto policy-based
routing (APBR). The Citrix Netscaler Application Delivery Controller (ADC) appliance automatically adds
the appropriate rules to the Cisco Nexus switch for APBR.
Before You Begin
Make sure that you are in the correct VDC on the Cisco Nexus switch. To switch VDCs, use the switchto
vdc command.
DETAILED STEPS
Command or Action
Step 1 switch# config term
Step 2 switch(config)# feature pbr
Step 3 switch(config)# exit
Configuring APBR on the Citrix NetScaler Application Delivery Controller
(ADC) Appliance
This section includes the following topics:

Configuring NSIP on the Appliance

The NetScaler management IP address (NSIP) is the IP address for management and general system access
to the Citrix NetScaler Application Delivery Controller (ADC) appliance and for high availability (HA)
communication.

Configuring NSIP Using the CLI

You can configure the NSIP on your appliance by using either the configuration prompts or the command-line
interface (CLI).
To prevent an attacker from impeding your ability to send packets to the appliance, choose a nonroutable
Note
IP address on your organization's LAN as your appliance IP address.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
54
Configuring Auto Policy-Based Routing
Purpose
Enters global configuration mode
Enables policy-based routing (PBR) on the Cisco Nexus Series
switch.
Exits the global configuration mode.