Enabling The Usip Option; Enabling The Usip Option For A Service - Cisco Nexus 7000 Series Configuration Manual

Configuring Auto Policy-Based Routing
• Configure the NetScaler IP address (NSIP) on the appliance.
Step 1 Navigate to System > Settings.
Step 2
In the details pane, under Settings, click Change NSVLAN Settings.
Step 3 In the Configure NSVLAN Settings dialog box, set the parameters. For a description of a parameter, hover the mouse
cursor over the corresponding field.
Step 4
Under Interfaces, choose the interfaces from the Available Interfaces list and click Add to move them to the Configured
Interfaces list.
Step 5
Click OK. In the Warning dialog box, click OK. The configuration takes effect after the Citrix NetScaler Application
Delivery Controller (ADC) appliance is restarted.

Enabling the USIP Option

APBR rules are configured on the Cisco Nexus Series switch by the Citrix Netscaler Application Delivery
Controller (ADC) appliance when the Use Source IP (USIP) option is enabled. Perform only one of the
following tasks to enable the USIP option on the Citrix Netscaler Application Delivery Controller (ADC)
appliance:

Enabling the USIP Option for a Service

To create a service and enable and set the Use Source IP (USIP) option on that service, type the following
commands at the command prompt:
Before You Begin
Ensure that the NSIP and NSVLAN are configured on the Citrix Netscaler Application Delivery Controller
(ADC) appliance.
Step 1
Use one of the following commands:
Option
add service service_name ipaddress
protocol-type port_number [-usip
[yes | no]
set service service_name [-usip yes]
Configuring APBR on the Citrix NetScaler Application Delivery Controller (ADC) Appliance
Description
Creates a service and enables the USIP option. The RISE appliance sends the
server address, port, protocol, and the IP address of the next-hop interface and
the VLAN to the Cisco Nexus switch.
The protocol-type argument specifies a supported protocol including but not
limited to the following keywords: dns, http, ssl, tcp, or udp.
Note IPv6 addresses are not
supported.
Enables the USIP option on a previously configured service.
Note This command is not required if you previously configured the specified
service using the add service command with the -usip keyword
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
57