Configuring Nsvlan Using The Configuration Utility; Configuring Rise In Vpc Mode (Recommended Deployment Mode) - Cisco Nexus 7000 Series Configuration Manual

Configuring RISE
• Configure the NS IP address (NSIP) on the appliance.
Step 1 set ns config - nsvlan positive_integer - ifnum interface_name ... [-tagged (YES | NO)]
You must reboot the appliance for the configuration to take effect.
Note
Step 2 (Optional) show ns config
set ns config -nsvlan 300 -ifnum 1/1 1/2 1/3 -tagged NO
save config
Step 3 (Optional) unset ns config -nsvlan
Restores the default configuration.

Configuring NSVLAN Using the Configuration Utility

Before You Begin
• Create a port channel on the Citrix NetScaler Application Delivery Controller (ADC) appliance and map
• Configure the NetScaler IP address (NSIP) on the appliance.
Step 1
Navigate to System > Settings.
Step 2 In the details pane, under Settings, click Change NSVLAN Settings.
Step 3 In the Configure NSVLAN Settings dialog box, set the parameters. For a description of a parameter, hover the mouse
cursor over the corresponding field.
Step 4 Under Interfaces, choose the interfaces from the Available Interfaces list and click Add to move them to the Configured
Interfaces list.
Step 5 Click OK. In the Warning dialog box, click OK. The configuration takes effect after the Citrix NetScaler Application
Delivery Controller (ADC) appliance is restarted.
Configuring RISE in vPC Mode (Recommended Deployment
Mode)
In a virtual port channel (vPC) deployment, two service appliances, such a Citrix NetScaler Application
Delivery Controller (ADC) appliance, are each connected to separate Cisco Nexus Series switches that are in
vPC mode through a peer link. This is the recommended topology for deploying the RISE feature on a Cisco
Nexus switch and a Citrix NetScaler Application Delivery Controller (ADC) appliance.
This section includes the following topics:
its physical ports to this port channel.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches

Configuring RISE in vPC Mode (Recommended Deployment Mode)

Configuration Guide
29