Configuring Nsip Using The Configuration Utility - Cisco Nexus 7000 Series Configuration Manual

Configuring Auto Policy-Based Routing
Before You Begin
Ensure that a port channel is configured on the appliance and that the appliance's physical ports are mapped
to this port channel.
Perform one of the following tasks:
Option
config ns
set ns config -ipaddress address -netmask netmask
add ns ip ip-address netmask -type type
add route network netmask gateway
save ns config
reboot
Example:
The following example shows how to configure the NSIP using the CLI:
set ns config -ipaddress 10.102.29.60 -netmask 255.255.255.0
add ns ip 10.102.29.61 255.255.255.0 -type snip
add route 0.0.0.0 0.0.0.0 10.102.29.1
save ns

Configuring NSIP Using the Configuration Utility

Before You Begin
• Create a port channel on the Citrix NetScaler Application Delivery Controller (ADC) appliance and map
Step 1 Navigate to System > Settings.
Step 2
In the details pane, under Settings, click Change NSIP Settings.
Step 3 In the Configure NSIP Settings dialog box, set the parameters. For a description of a parameter, hover the mouse cursor
over the corresponding field.
Step 4
Under Interfaces, choose the interfaces from the Available Interfaces list and click Add to move them to the Configured
Interfaces list.
Step 5 Click OK. In the Warning dialog box, click OK. The configuration takes effect after the Citrix NetScaler Application
Delivery Controller (ADC) appliance is restarted.
Configuring APBR on the Citrix NetScaler Application Delivery Controller (ADC) Appliance
its physical ports to this port channel.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Description
Displays prompts for configuring the NSIP.
Configures the NSIP using the CLI.
Configuration Guide
55