Configuring Nsip On The Appliance; Configuring Nsip Using The Cli - Cisco Nexus 7000 Series Configuration Manual

Configuring RISE
Command or Action
Step 8
switch(config-rise)# no
shutdown
Step 9 switch(config-rise)# show
module service
Step 10
switch(config-rise)# attach
rise {slot slot-number | name
name}
Step 11 switch(config-rise)# show rise

Configuring NSIP on the Appliance

The NetScaler management IP address (NSIP) is the IP address for management and general system access
to the Citrix NetScaler Application Delivery Controller (ADC) appliance and for high availability (HA)
communication.

Configuring NSIP Using the CLI

You can configure the NSIP on your appliance by using either the configuration prompts or the command-line
interface (CLI).
Purpose
Launches the auto-discovery and bootstrap configuration process. The Citrix NetScaler
Application Delivery Controller (ADC) appliance port channel is created with the RISE
IP address set at the Citrix NetScaler Application Delivery Controller (ADC) appliance.
Note The Cisco Nexus Series switches associates the NetScaler appliance serial
number with the virtual slot number for this Citrix NetScaler Application
Delivery Controller (ADC) appliance.
Discovery does not start if any required information (such as the port, RISE
Note
VLAN, RISE IP address, or switch virtual interface [SVI] of the RISE VLAN)
is not provided. If the discovery times out, the virtual module is shown in the
inactive state. The show rise command on the switch displays the reason for
discovery failure.
(Optional) Displays the status of the RISE service module on the Cisco Nexus Series
switch. If the RISE service module is operational, the status that is displayed is "active."
(Optional) Connects the Cisco Nexus Series switch to the RISE service module and
generates a RISE session from the switch, which allows Telnet access.
• The slot number range varies based on the valid slot numbers for a particular VDC.
The Cisco Nexus Series switch supports 32 RISE instances per VDC. The slot
number range is as follows:
• From 300 to 331 for VDC 1
• From 332 to 363 for VDC 2
• From 364 to 395 for VDC 3
• From 396 to 427 for VDC 4
• You can enter up to 32 alphanumeric characters for the RISE service module name.
• After you enter the password, you can access the Citrix NetScaler Application
Delivery Controller (ADC) appliance to configure it.
Displays the RISE configuration status on the Cisco Nexus Series switch. If RISE is
configured on the switch, the state that is displayed is "active."
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuring RISE in a vPC Indirect Mode Deployment
Configuration Guide
35