Cisco Nexus 7000 Series Configuration Manual page 33

Configuring RISE
Command or Action
Step 7 switch(config-rise)# vlan group
vlan-group
Step 8 Use one of the following:
• switch(config-rise)#
ethernet slot/port
• switch(config-rise)#
port-channel
channel-number
Step 9
switch(config-rise)# no
shutdown
Step 10 switch(config-rise)# show
module service
Step 11 switch(config-rise)# attach rise
{slot slot-number | name name}
Purpose
This IP address controls message communication with the supervisor over the RISE
port channel. The same IP address can be used for the management IP address of
NetScaler appliance.
Specifies the RISE VLAN group to be used by Citrix Netscaler Application Delivery
Controller (ADC) appliance.
The range is from 1 to 32.
The trunk-allowed VLANs on the port channel must include all of the VLANs
Note
in the VLAN group as well as the VLAN for the RISE control message.
Creates an interface for sending out RISE discovery packets.
• The range for the slot argument is from 1 to 253. The range for the port argument
is from 1 to 128.
• The range for the channel-number argument is from 1 to 4096.
Launches the auto-discovery and bootstrap configuration process. The NetScaler ADC
appliance port channel is created with the RISE IP address set at the Citrix Netscaler
Application Delivery Controller (ADC) appliance.
The Cisco Nexus Series switches associates the Netscaler Application Delivery
Note
Controller (ADC) appliance serial number with the virtual slot number for
this Cisco Netscaler Application Delivery Controller (ADC) appliance.
Discovery does not start if any required information (such as the port, RISE
Note
VLAN, RISE IP address, or switch virtual interface [SVI] of the RISE VLAN)
is not provided. If the discovery times out, the virtual module is shown in the
inactive state. The show rise detail command on the switch displays the
reason for discovery failure.
(Optional) Displays the status of the RISE service module on the Cisco Nexus Series
switch. If the RISE service module is operational, the status that is displayed is "active."
(Optional) Connects the Cisco Nexus Series switch to the RISE service module and
generates a RISE session from the switch, which allows Telnet access.
• The slot number range varies based on the valid slot numbers for a particular
VDC. The Cisco Nexus Series switch supports 32 RISE instances per VDC. The
slot number range is as follows:
• From 300 to 331 for VDC 1
• From 332 to 363 for VDC 2
• From 364 to 395 for VDC 3
• From 396 to 427 for VDC 4
• You can enter up to 32 alphanumeric characters for the RISE service module
name.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuring Cisco RISE in a Direct Mode Deployment
Configuration Guide
23