Cisco 500 Series Administration Manual page 590

Access Control
IPv4-based ACLs
Cisco 500 Series Stackable Managed Switch Administration Guide
Shutdown
- —Drop packet that meets the ACE criteria and disable the port
to which the packet was addressed. Ports are reactivated from the Port
Management page.
• Logging—Select to enable logging ACL flows that match the ACL rule.
• Time Range—Select to enable limiting the use of the ACL to a specific time
range.
• Time Range Name—If Time Range is selected, select the time range to be
used. Time ranges are defined in the
• Protocol—Select to create an ACE based on a specific protocol or protocol
ID. Select Any (IPv4) to accept all IP protocols. Otherwise select one of the
following protocols from the drop-down list Selected from list:
ICMP
- —Internet Control Message Protocol
IGMP
- —Internet Group Management Protocol
IP in IP
- —IP in IP encapsulation
TCP
- —Transmission Control Protocol
EGP
- —Exterior Gateway Protocol
IGP
- —Interior Gateway Protocol
UDP
- —User Datagram Protocol
HMP
- —Host Mapping Protocol
RDP
- —Reliable Datagram Protocol.
IDPR
- —Inter-Domain Policy Routing Protocol
IPV6
- —IPv6 over IPv4 tunneling
IPV6:ROUT
- —Matches packets belonging to the IPv6 over IPv4 route
through a gateway
IPV6:FRAG
- —Matches packets belonging to the IPv6 over IPv4 Fragment
Header
IDRP
- —Inter-Domain Routing Protocol
RSVP
- —ReSerVation Protocol
AH
- —Authentication Header
IPV6:ICMP
- —Internet Control Message Protocol
Configuring System Time
27
section.
588