Cisco 500 Series Administration Manual page 173

9
STEP 1
STEP 2
171
The LLDP-MED TLVs to be advertised can be selected in the LLDP MED Interface
Settings page.
To define the CDP interface settings:
Click Administration > Discovery - CDP > Interface Settings.
This page displays the following CDP information for each interface.
• CDP Status—CDP publishing option for the port.
• Reporting Conflicts with CDP Neighbors—Status of the reporting options
that are enabled/disabled in the Edit page (Voice VLAN/Native VLAN/
Duplex).
• No. of Neighbors—Number of neighbors detected.
The bottom of the page has four buttons:
• Copy Settings—Select to copy a configuration from one port to another.
• Edit—Fields explained in Step 2 below.
• CDP Local Information Details—Takes you to the Administration > Discovery
- CDP > CDP Local Information page.
• CDP Neighbor Information Details—Takes you to the Administration >
Discovery - CDP > CDP Neighbor Information page.
Select a port and click Edit.
This page provides the following fields:
• Interface—Select the interface to be defined.
• CDP Status—Select to enable/disable the CDP publishing option for the
port.
The next three fields are operational when the device has been set up
NOTE
to send traps to the management station.
• Syslog Voice VLAN Mismatch—Select to enable sending a SYSLOG
message when a voice VLAN mismatch is detected. This means that the
voice VLAN information in the incoming frame does not match what the local
device is advertising.
Cisco 500 Series Stackable Managed Switch Administration Guide
Administration: Discovery
Configuring CDP