Cisco 500 Series Administration Manual page 413

19
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
411
Redistribute Static Route—Select to enable this feature (described in
Redistribution Feature.
If Redistribute Static Route is enabled, select an option for the Redistribute
Connected Metric field. The following options are available:
• Default Metric—Causes RIP to use the default metric value for the
propagated static route configuration (refer to
• Transparent—Causes RIP to use the routing table metric as the RIP metric
for the propagated static route configuration. This results in the following
behavior:
- If the metric value of a static route is equal to or less than 15, this value is
used in the RIP protocol when advertising this static route.
- If the metric value of a static route is greater than 15, the static route is not
advertised to other routers using RIP.
• User Defined Metric—Enter the value of the metric.
Redistribute Connected Route—Select to enable this feature (described in
Redistributing Static Route Configuration.
If Redistribute Connected Route is enabled, select an option for the Redistribute
Static Metric field. The following options are available:
• Default Metric—Causes RIP to use the default metric value for the
propagated static route configuration (refer to
• Transparent—Causes RIP to use the routing table metric as the RIP metric
for the propagated static route configuration. This results in the following
behavior:
- If the metric value of a static route is equal to or less than 15, this value is
used in the RIP protocol when advertising this static route.
- If the metric value of a static route is greater than 15, the static route is not
advertised to other routers using RIP.
• User Defined Metric—Enter the value of the metric.
Click Apply. The settings are written to the Running Configuration file.
Cisco 500 Series Stackable Managed Switch Administration Guide
IP Configuration: RIPv2
Configuring RIP
Redistribution Feature).
Redistribution Feature).