Mld Proxy - Cisco 500 Series Administration Manual

Multicast
IPv6 Multicast Configuration
STEP 2
STEP 3
NOTE
STEP 1
STEP 2
STEP 3
Cisco 500 Series Managed Switch Administration Guide
To configure a VLAN, select it and click Edit. Enter the fields described above.
Click Apply. The Running Configuration file is updated.

MLD Proxy

This page is only found on SG500X/SG500XG devices.
To configure MLD Proxy:
Click Multicast > IPv6 Multicast Configuration > MLD Proxy.
Enter the following fields:
• MLD Multicast Routing—Select to enable IPv6 Multicast routing.
• Downstream Protection—Select to discard downstream packets not
required for the device.
• Source Specific Multicast—Select to enable delivering Multicast packets
originating from a specific source address defined in the next field.
• SSM IPv6 Access List—Define the list containing source addresses from
which to deliver Multicast packets:
- Default List—Defines the SSM range access list to FF3E::/32.
- User defined access list—Select the standard IPv6 access list name
defining the SSM range. These access lists are defined in
Lists.
Click Apply. The Running Configuration file is updated.
To add protection to a VLAN, click Add and enter the following fields:
• Upstream Interface—Select the outgoing interface.
• Downstream Interface—Select the incoming interface.
• Downstream Protection—Select one of the following options:
- Use Global—Use the status set in the global block.
- Disable—This disables forwarding of IPv6 Multicast traffic from
downstream interfaces.
- Enable—This enables forwarding from downstream interfaces.
17
IPv6 Access
334