Cisco 500 Series Administration Manual page 412

IP Configuration: RIPv2
Configuring RIP
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
- Configure the offset added to the metric for incoming routes on an IP
interface, using the RIPv2 Settings page.
- Enable passive mode on an IP interface, using the RIPv2 Settings page.
- Control which routes are processed in the incoming/outgoing routing
updates by specifying an IP address list on the IP interface (see
Lists).
- Advertise default route entries on the IP interface, using the RIPv2
Settings page.
- Enable RIP authentication on an IP Interface, using the RIPv2 Settings
page.
RIPv2 Properties
To enable/disable RIP on the device.
Click IP Configuration > IPv4 Management and Interfaces> RIPv2 > RIPv2
Properties.
Select the following options as required:
• RIP—The following options are available:
- Enable—Enable RIP.
- Disable—Disable RIP. Disabling RIP deletes the RIP configuration on the
system.
- Shutdown—Set the RIP global state to shutdown.
• RIP Advertisement—Select to enable sending routing updates on all RIP IP
interfaces.
• Default Route Advertisement—Select to enable sending the default route
to the RIP domain. This route will serve as the default router.
• Default Metric—Enter the value of the default metric (refer to
Redistribution Feature).
19
Access
410