6
STEP 1
111
If IPv6 routing is enabled on the device, the following table describes the number
of TCAM entries used by the various features:
Logical Entity
IP Neighbor
IP Address on an interface
IP Remote Route
On-Link-Prefix
The Routing Resources page enables you to adjust the TCAM allocation.
If you change the TCAM allocation incorrectly, an error message is displayed. If
your TCAM allocation is feasible, a message is displayed that an automatic reboot
will be performed with the new settings. Routing resources can be modified
incorrectly, in one of the following ways:
•
The number of TCAM entries you allocate is less than the number currently
in use.
•
The number of TCAM entries that you allocate is greater than the maximum
available for that category (maximum values are displayed on the page).
To view and modify routing resources:
Click Administration > Routing Resources.
The following fields are displayed for IPv4 Routing Resources:
•
Neighbors(1 TCAM entry per neighbor)—Count is the number of
neighbors recorded on the device and TCAM Entries is the number of TCAM
entries being used for the neighbors.
•
Interfaces(2 TCAM entries per interface)—Count is the number of IP
addresses on interfaces on the device and TCAM Entries is the number of
TCAM entries being used for the IP addresses.
•
Routes (1 TCAM entry per route)—Count is the number of routes recorded
on the device and TCAM Entries is the number of TCAM entries being used
for the routes.
•
Total—Displays the number of TCAM entries which are currently being
used.
IPv4
1 entry
2 entries
1 entry
Cisco 500 Series Stackable Managed Switch Administration Guide
Administration
Routing Resources
IPv6 (PCL
IPv6 (Router
TCAM)
TCAM)
1 entry
4 Entries
2 entries
8 entries
1 entry
4 Entries
1 Entry
4 Entries