Cisco 500 Series Administration Manual page 274

VLAN Management
VLAN Groups
Cisco 500 Series Stackable Managed Switch Administration Guide
• PVID—VLAN is taken from the port default VLAN ID.
MAC-based Groups
MAC-based VLAN classification enable packets to be classified according to their
source MAC address. You can then define MAC-to-VLAN mapping per interface.
You can define several MAC-based VLAN groups, which each group containing
different MAC addresses.
These MAC-based groups can be assigned to specific ports/LAGs. MAC-based
VLAN groups cannot contain overlapping ranges of MAC addresses on the same
port.
The following table describes the availability of MAC-based VLAN groups in
various SKUs:
Table 6 MAC-Based VLAN Group Availability
SKU
Sx300
Sx500,
Sx500ESW2-
550X
SG500X
SG500XG
Workflow
To define a MAC-based VLAN group:
1. Assign a MAC address to a VLAN group ID (using the MAC-Based Groups
page).
2. For each required interface:
System Mode
Layer 2
Layer 3
Layer 2
Layer 3
Native
Basic Hybrid - Layer 2
Basic Hybrid - Layer 3
Same as Sx500
MAC-based VLAN Groups
Supported
Yes
No
Yes
No
Yes
Yes
No
Yes
14
272