IP Configuration
IPv6 Management and Interfaces
STEP 4
NOTE
STEP 1
STEP 2
Cisco 500 Series Managed Switch Administration Guide
•
Lower Than—Maximum prefix length to be used for matching. Select one of
the following options:
-
No Limit—No maximum prefix length to be used for matching.
-
User Defined—Maximum prefix length to be matched.
•
Description—Enter a description of the prefix list.
Click Apply to save the configuration to the Running Configuration file.
IPv6 Access Lists
This page is only found on SG500X/SG500XG devices.
Use this page to create access lists used in MLD proxy. See
To create an SSM access list in Layer 2 mode:
Click Administration > Management Interface > IPv6 Routes.
-or
To create an SSM access list in Layer 3 system mode:
Click IP Configuration > IPv6 Management and Interfaces > IPv6 Routes.
All SSM access lists are displayed.
Click Add and enter the following fields:
•
Access List Name—Select one of the following options:
-
Use existing list—Select a previously-defined SSM access list.
-
Create new list—Enter the name of a new list.
•
Interface—Interface used to forward the packet.
•
Source IPv6 Address List—Select one of the following options:
-
Any—Any IPv6 address can be the source.
-
User Defined—Only the specified IPv6 address can be the source.
•
Prefix length—Enter the prefix length of the source IPv6 address.
•
Action—Select one of the following options:
-
Permit—Permit passage of the source IPv6 Address.
18
MLD
Proxy.
394