Configuring the ML-Series POS Interfaces
Command
Step 1
Router(config)# interface pos
number
Step 2
Router(config-if)# pos report
{all | encap | pais | plop | ppdi
| pplm | prdi | ptim | puneq |
sd-ber-b3 | sf-ber-b3}
Step 3
Router(config-if)# end
Step 4
Router# copy running-config
startup-config
To determine which alarms are reported on the POS interface and to display the bit error rate (BER)
thresholds, use the show controllers pos command, as described in the
POS Interface and POS Controller" section on page
Cisco IOS alarm reporting commands apply only to the Cisco IOS CLI. SONET/SDH alarms reported
Note
to the CTC are not affected.
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
4-16
Purpose
Enters interface configuration mode and specifies the POS
interface to configure.
Permits logging of selected SONET/SDH alarms. Use the no
form of the command to disable reporting of a specific alarm.
The alarms are as follows:
all—All alarms/signals
•
encap—Path encapsulation mismatch
•
pais—Path alarm indication signal
•
plop—Path loss of pointer
•
ppdi—Path payload defect indication
•
•
pplm—Payload label, C2 mismatch
•
prdi—Path remote defect indication
ptim—Path trace identifier mismatch
•
puneq—Path label equivalent to zero
•
sd-ber-b3—PBIP BER in excess of SD threshold
•
sf-ber-b3—PBIP BER in excess of SF threshold
•
Returns to the privileged EXEC mode.
(Optional) Saves configuration changes to NVRAM.
4-13.
Chapter 4
Configuring Interfaces
"Monitoring Operations on the
78-15224-02