Monitoring Operations On The Pos Interface And Pos Controller - Cisco ONS 15454 Software Feature And Configuration Manual

Chapter 4 Configuring Interfaces

Monitoring Operations on the POS Interface and POS Controller

The following output from the show interface command displays the POS interface's status and global
parameters:
Router# show interface pos 0
POS0 is up, line protocol is up
Hardware is Packet/Ethernet over Sonet, address is 0005.9a39.6630 (bia 0005.9a
39.6630)
MTU 1500 bytes, BW 311040 Kbit, DLY 100 usec,
Encapsulation ONS15454-G1000, crc 32, loopback not set
Keepalive set (10 sec)
Scramble enabled
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:02:34, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
The following output from the show controllers command displays the POS controllers:
Router# show controllers pos 0
Interface POS0
Hardware is Packet/Ethernet over Sonet
PATH
PAIS
PPLM
BER_SF_B3 = 0
NEWPTR
Active Alarms : None
Demoted Alarms: None
Active Defects: None
Alarms reportable to CLI: PAIS PRDI PLOP PUNEQ PPLM PTIM PPDI BER_SF_B3 BER_
3
Link state change defects: PAIS PLOP PRDI PPDI BER_SF_B3
Link state change time
DOS FPGA channel number: 0
Starting STS (0 based) : 0
Circuit size
RDI Mode
C2 (tx / rx)
Framing
Path Trace
Mode
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
reliability 255/255, txload 1/255, rxload 1/255
1107 packets input, 11267427 bytes
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 parity
1 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
= 1 PLOP
= 0 PUNEQ
BER_SD_B3 = 0
= 1 PSE
: 200 (msec)
: STS-6c
: 1 bit
: 0x01 / 0x01
: SONET
: off
= 0 PRDI = 0
= 0 PPDI = 0
BIP(B3) = 2975
= 0 NSE = 0
Configuring the ML-Series POS Interfaces
PTIM = 0
REI = 7
4-13