Displaying ML-Series Ethernet Ports Provisioning Information on CTC
Figure 2-3
The Provisioning > Ether Ports tab displays the following information:
Port Name—Configurable identifier for the port.
•
Admin State—Configured port state, which is administratively active or inactive. Possible values are
•
UP and DOWN.
Link State—Status between signalling points at port and attached device. Possible values are UP and
•
DOWN.
MTU—(maximum transfer unit) Largest acceptable packet size configured for that port. Default
•
value is 1500.
Speed—ML1000-2 possible values are Auto or 1Gbps. ML100T-12 possible values are Auto,
•
10Mbps or 100Mbps.
Duplex—Setting of the port. ML1000-2 possible values are Auto or Full. ML100T-12 possible
•
values are Auto, Full, or Half.
Flow Control—Negotiated flow control mode. Possible values are None, Symmetrical, and
•
Asymmetrical.
Optics—Small form-factor pluggable (SFP) physical media type. Possible values are Unplugged,
•
1000 SX, or 1000 LX. (This information does not apply to the ML100T-12 card.)
Auto indicates the port is set to auto-negotiate capabilities with the attached link partner.
Note
The port name field configured in CTC and the port name configured in Cisco IOS are independant of
Note
each other. The name for the same port under Cisco IOS and CTC will not match, unless the same name
is used to configure the port name in both CTC and Cisco IOS.
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
2-6
Displaying ML-Series Ethernet Port Provisioning Information
Chapter 2
CTC Operations
78-15224-02