Encapsulation Over Etherchannel Example; Figure 9-3 Encapsulation Over Etherchannel Example - Cisco ONS 15454 Software Feature And Configuration Manual

Configuring POS Channel
Command
Step 6
Router(config-subif)# encapsulation dot1q
vlan-id
Step 7
Router(config-subif)# bridge-group
bridge-group-number
Step 8
Router(config-subif)# end
Step 9
Router# copy running-config startup-config

Encapsulation over EtherChannel Example

Figure 9-3
the sections that follow the figure.
Figure 9-3
Fast Ethernet 1
This encapsulation over EtherChannel example shows how to set up two ONS 15454s with ML100T-12
cards (Switch A and Switch B) to interoperate with two switches that also support 802.1Q encapsulation
over EtherChannel. To set up this example, use the configurations in the following sections for both
Switch A and Switch B.
Switch A Configuration
hostname Switch A
!
bridge irb
bridge 1 protocol ieee
bridge 2 protocol ieee
!
interface Port-channel1
no ip address
hold-queue 150 in
!
interface Port-channel1.1
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
9-8
shows an example of encapsulation over EtherChannel. The associated code is provided in
Encapsulation over EtherChannel Example
POS 0
Fast Ethernet 0
802.1Q Trunking
VLANs 1 & 2
Chapter 9
Purpose
Assigns the 802.1Q encapsulation to the
subinterface.
Assigns an interface to a bridge group.
Exits to privileged EXEC mode.
Note Optionally, you can remain in interface
configuration mode and enable other
supported interface commands to meet
your requirements.
(Optional) Saves the configuration changes to
NVRAM.
SONET STS-1 POS 0
Fast Ethernet 0
802.1Q Trunking
VLANs 1 & 2
Configuring Link Aggregation
Fast Ethernet 1
78-15224-02