Basic Ip Routing Protocol Configuration; Rip - Cisco ONS 15454 Software Feature And Configuration Manual

Basic IP Routing Protocol Configuration

For IP routing, you need the following to configure your interface:
•
•
You also need to do the following:
•
•
The ML Series supports the routing protocols listed and described in the following sections.
Basic IP Routing Protocol Configuration
To configure IP routing protocols to run on a Fast Ethernet, Gigabit Ethernet, or POS interface, perform
one of the following procedures, depending on the protocol you are configuring.

RIP

To configure the RIP protocol, perform the following procedure, beginning in global configuration
mode:
Command
Step 1
Router(config)# router rip
Step 2
Router(config-router)# network
net-number
Step 3
Router(config-router)# exit
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
10-2
IP address
IP subnet mask
Select a routing protocol.
Assign IP network numbers to be advertised.
Chapter 10
Purpose
Enters router configuration mode, defines RIP as the
routing protocol, and starts the RIP routing process.
Specifies a directly connected network based on the
Internet Network Information Center (InterNIC) network
number—not a subnet number or individual address. The
routing process associates interfaces with the appropriate
addresses and begins processing packets on the specified
network.
Returns to global configuration mode.
Configuring Networking Protocols
78-15224-02