Cisco ONS 15454 Software Feature And Configuration Manual page 206

show interface pos <interface-number>
show interface pos <interface-number>
Use this command to display the status of the POS.
Parameter
interface-number
Defaults N/A
Command Modes
Privileged EXEC
Usage Guidelines This command may be used to help diagnose and isolate POS or SONET/SDH problems.
Examples
Gateway#show interfaces pos0
POS0 is up, line protocol is up
Hardware is Packet/Ethernet over Sonet
Description: foo bar
MTU 4470 bytes, BW 155520 Kbit, DLY 100 usec,
Encapsulation HDLC, crc 32, loopback not set
Keepalive set (10 sec)
Scramble enabled
Last input 00:00:09, output never, output hang never
Last clearing of "show interface" counters 05:17:30
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
A-10
Description
Number of the POS interface <0-1>
reliability 255/255, txload 1/255, rxload 1/255
2215 total input packets,
0 input short packets,
0 input long packets , 0
0 input CRCerror packets , 0
0 input abort packets
0 input packets dropped by ucode
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2216 total output packets, 223807
224003 output post-HDLC bytes
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 8 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
223743 post-HDLC bytes
223951 pre-HDLC bytes
input runt packets
input drop packets
output pre-HDLC bytes
Appendix A Command Reference
78-15224-02